寧波Winkay自動車部品技術有限公司                                                                                                                                                       
連絡先情報

    寧波WINKAY自動車部品技術有限公司は長い間、自動車EFI付属品および自動車電子および電気付属品の信頼性が高く適正な価格を顧客に提供してきました。 当社の製品は次のとおりです。イグニッションコイル、電子スロットル、エアフローメーター、アイドルスピードモーター、油圧クラッチレリーズベアリング、あらゆる種類の自動車用スイッチ、あらゆる種類の自動車用センサー。

    Address: West Shunyu Road, Yangming Street, Yuyao, Ningbo, Zhejiang Province, China

    Tel: +86-574-62792501

    E-mail: master@winkay.com

    WEBSITE: https://www.winkay.com

あなたの場所:ホーム > ニュース > 業界ニュース

Troubleshooting procedure for ignition coil failure

2005/1/5      点击:


The ignition coil mainly supplies ignition energy to the ignition system of the engine. The failure rate of the coil itself is very low, but the failure of the coil cannot be completely eliminated. When the ignition coil fails, the ignition energy of the engine is insufficient, which may cause the engine to idle and the operation is unstable. Deterioration and other failures.

The ignition coil troubleshooting process is as follows:


Step 1 :
Set the ignition switch to "ON"


Step 2:
Unplug the ignition coil connector on the harness and use a multimeter to check if there is a battery voltage of about 12V between the 3rd pin and the ground wire on the connector.
If yes, please continue to the next step; if no, please check the line.

 
Step 3:
Unplug the ignition coil connector on the harness and use a multimeter to check if the No. 1 pin on the connector and the 5# of the ECU are short-circuited or open.
If yes, please check the line and ECU; if no, proceed to the next step.

 
Step 4:
Unplug the ignition coil connector on the harness and use a multimeter to check if the 2nd pin on the connector and the 2# of the ECU are short-circuited or open.
If yes, please check the line and ECU; if no, proceed to the next step.

Step 5:
Check if the primary coil resistance of the sensor is about 0.9Ω.
If yes, proceed to the next step; if not, replace the ignition coil.


Step 6:
Check if the secondary winding resistance of the sensor is about 14.5kΩ.
If yes, proceed to the next step; if not, replace the ignition coil.

Step 7:
Use an oscilloscope to check if the secondary ignition waveform of the high voltage line of the ignition system is normal.


If yes then check other parts.



点火线圈电路图  ▼


Copyright 2019 | www.winkay.com | SITEMAP | Ningbo Winkay Auto Parts Technology Co., Ltd.- All Rights Reserved

share
+86-574-62792501